Automatic Rigid Box LineDigital line for the production of rigid, angled, tall and cost saving ‘T shape’ & cross shape covered boxes.Very low use, in ‘like new’ condition!Equipped with:EPQ175SB/1 Automatic Quad Stayer- High Pile Feeder for Board Blanks- Feeder with non-stop device.- Double board blanks warning system with machine stop- Board blanks feeding through suckers with lift at the front edge- Sliding system with rolls and belts at adjustable speed to eliminate breaking of board blanks- Precise location of board blanks under forming block with pushers- Precision adjustment of forming block position through brushless motor- Large diameter thermo-tape reels located on the side of the machine with an “end-of –reel”acoustic signal. Facility to change reel without stopping machine- Thermo tape heat-sealing system with adjustable pressure pads on the corners of forming block- “Cross-shaped” and “T-shaped” stitching system.- Box ejection by cylinder and suction to position the box precisely on conveyor belt- Box transport system to the spotter with 2 operating modes- Digital display and temperature control of the 4 heat sealing tape anvilsALFACEHB5” Automatic Gluing Machine- Automatic Glue Viscosity Control Unit- Automatic sheet feeder with lifting the rear of the sheet for the insert of papers up to 300 g/m2- Stainless steel, chromed and rectified glue rolls- Rollers/belt speed automatic adjustment- Vacuum conveyor with running digitally adjustable gap control- Servo driven motor on vacuum conveyor with mm by mm variable step control- Centralised lubrication- Strong aluminium vacuum suction channel with guides for suction conveyor belt- Perforated green conveyor belt in polyurethane, with higher suction capacity to the centre- Additional vacuum box for small sheets- Controlled acceleration and deceleration of conveyor belt, motor driven- Auto sheet detection - if glue pickers not lowered, paper will not feed- Glue Tank “GTCEC02” with capacity of 70 litres- Anti-air bubbles systemEPS175SB Automatic Spotter- Choice of left or right-hand side- Suction speed adjustable with inverter- Box unloading even without research- Paper reading by three optic fibres and hydraulic control unit- Mechanical guide unit to control box movement during positioning- Simple size change-overEPW175SB Automatic Wrapping Machine- The wrapper is the Master of the line- Possibility of ‘T’ shape wrap for boxes up to 60 mm width- Correct ergonomic working height- Work cycle controlled by P.L.C - no mechanical cam- Possibility to lift box from belt- Easy fixing and locking tools- Regulating pressing time up to 9,99 seconds- Standard or sequential inside turn-in- Possibility of inside wrapping up to 70 mm- 800 job programs storageAccessories:- Kit for window box- Kit for lateral turn-in up to 80mm- Tooling for bottom or lid